Designer Registry Search

Person with ATT designation is qualified to complete air tightness testing on homes for OBC/NBC compliance.

A BCEM is qualified to use REM/Rate software to demonstrate Energy Performance for Building Code Compliance

Identifying service capacity of existing load on main breaker to determine excess capacity available for new Air Source Heat Pump.

Person who has obtained all three designations: Building Code Energy Modeller, Air Tightness Tester, and Field Inspector.

Design of a Residential Forced Air distribution system serving a house or a dwelling unit including, but not limited to, the layout, sizing and selection of equipment, ducts, grilles and registers as well as any other peripheral accessories

On-site testing of HVAC ductwork system for central airflow and static pressure according to CSA C-750.

Determine the required capacity of residential space heating and cooling appliances based on the CSA-F280-12 standard. CSA-F280-12 is recognized throughout Canada and referenced by all Canadian Building Codes.

Design of Hydronic Systems in residential buildings to meet the requirements of relevant Canadian Codes and standards.

Determine the required capacity of residential space heating and cooling appliances based on the CSA-F280-12 standard for a whole dwelling unit. This calculation applies to renovation & retrofit where only the equipment is replaced. For new homes and for distribution system design, the RHLG designation is required.

Determine the heating, cooling and ventilation requiremets for Small Commercial Buildings within the Scope of Part 9, subject to the occupancy class restrictions of the relevant Provincial Building Codes

Design of Forced Air Heating, Cooling and Ventilation systems serving Small Commercial Buildings within the Scope of Part 9, subject to the occupancy class restrictions of the relevant Provincial Building Codes. This includes equipment selection, layout and design of duct systems as well as grille, diffuser & register selection.

Design of a Single Dwelling Unit Mechanical Ventilation System for residential homes to meet the requirement of the British Columbia Building Code.

Design of a Mechanical Ventilation System for residential homes that satisfies Building Code requirements throughout Canada based on the CAN/CSA-F326-M19 standard. CSA-F326 allows for more flexibility and has no scope restrictions compared to local Building Codes.

Design of a Single Dwelling Unit Mechanical Ventilation System for residential homes to meet the requirement of the National Building Code.